# CONFIG.INI for PC-CONFIG from Version 8.3 # Lines beginning with # are comments only # Possible switches Schalter: 1/0, ON/OFF # Identify installed memory size and speed of graphics adapter? # NB! For this test graphics modi are switched. If CONFIG is running under # WINDOWS in a window, you must disable this test. VideoTest=off # Tries to identify the chip-set on the graphics adapter? VGATest=on # Test for S3 VGA by direct hardware-access? TestS3=on # Test access times for the hard disk(s)? AccessTest=on # Get harddisksize with Int13 Extensions? # (may crash on older machines) INT13Ext=on # Always force the data transfer speed test for hard disks, even if an # active cache is detected? ForceHDspeed=on # Switch to off, if accesstest is'nt working on your SCSI disk MoveHeadOnly=on # Test for an active HD cache? HDCacheTest=on # Test for BIOS-Power Saving routines? APMTEST=on # Try to identify some older mainboard chipset via hardwaretest. This # causes some computers to crash, and can be disabled. TestBoard=off # Enter boardchipset manually, if detection should fail. # These numbers are vaild: # 0:Autodetect 1:UMC 2:SIS 3:CONTAC 4:ELITE # 5:FOREX 6:OPTI 7:ETEQ 8:SYMPHONY 9:SHASTA Chipsatz=0 # Choose your own name for the popular Intel FX430 chipset. # This is due to trademark rights in germany. Tname=TRIxxx # Test the access speed for Extended Memory? (Can be switched off if # this test leads to crashes (because of privilege violations etc.) TestExtMem=on # Do testing of the short interval timer? The test doesn't work on some # fast boards, so it can be disabled here: TimerTest=off # Try to get information about IDE hard disks? Can cause problems # with certain MFM/RLL contollers (eg OMTI 8250). # For registered users only! ATbusInfo=on # Look for sound cards? SearchForSoundCards=on # Minimum required CD-ROM size in MB. If you don't have such a big CD, # you can reduce the value, but the access times are only accurate with # CDs of 600 MB or above. MinCDsize=600 # Define Megabyte for harddisk-capacity: 1000x1000 or 1024x1024 byte Kilobyte=1000 # Look for programs loaded in Hi-Dos? HiDosSearch=on # In case the RAM disk was not detected, its allocated drive letter # (letter only) can be specified here. RamDisk= # A particular drive can be specified here for the DOS read/write # benchmark test. If 0 specified, the test is skipped. If left blank, # the current drive at the time of test will be tested. DosDisk= # Enable 'Expired' Window Expire=on # Use MSR10 to calculate cpu clock rate (any fail on some pentium) USEMSR10=on # Make a warning when started from within Windows WINWARN=on